How To Install The Portable Folding Table

　　A portable folding table is a very common table and chair, which is very convenient for outdoor and home use, so how should it be installed? This article will give you an introduction to "how to install a portable folding table" so that you can have a reference in your life. Let's follow Zhejiang RealGroup Co., Ltd to learn about it.

　　1. Preparations before assembly: Preparation tools: Phillips or flat-blade screwdriver, wrench, pencil, and pistol drill are recommended. Insert the circular fixed head into the punched hole and expose the crossed side of the connector.

　　2. Screw the connecting rod into the expansion plug that has been embedded in the plate, it is best not to screw it to the end. Use the No. 14 wrench to install the universal wheel into the moving door marked on the drawing. Don't screw it to the end first, and adjust the height later.

　　3. Screw the handle into the punched handle hole, pay attention to the front and back of the door panel, the side without the hinge hole is the front side, the handle screw may be too long, so 2 circular holes in the center are added to the hardware package, place the spacer between the screw and the door panel.

　　4. When leaving the factory, only the hinge screw holes are pre-drilled on the moving door and door panel in advance, and the hinge holes of the two side panels and the top panel are not pre-drilled so that the buyer can install it easier and with less error. , can only make the buyers tired and screw a few more screws. The screws that fix the hinges are self-tapping, which can be easily screwed in with a screwdriver even if there is no pre-drilled hole.

　　5. Turn the folding table upside down, the top plate touches the ground, and use the hinge to connect the No. 2 tabletop and the No. 1 top plate together. Move the door panel to support the tabletop, insert the pin head into the hole on the back of the tabletop, draw the position with a pencil on the moving door and fix the pin. The pinhole is not pre-drilled.

　　6. When assembling the portable folding table, a felt cloth or cardboard box should be laid on the ground to avoid scratches on the table. When installing the hinge, because the surface of the board is relatively hard, it is difficult to screw in the screws. You can press the screws first, and tap the screws with a hammer a few times, so that the board leaves a small hole that is recessed so that it is easy to screw in. A set of tables needs 24 sets of fixed heads and connecting rods, and 24 sets of spare parts are put in during the packaging. Buyers, please do not say that there are missing parts.